Pabloantxon
New member
Hi!
I have a Teensy 3.6 that I bought a while ago and used it for some tests, and have been sitting in a drawer until now.
When I connect it to a pc (tried on two pcs, windows and linux) it doesn't appear. The blink sketch is long gone so I can't use that for knowing if it works.
I saw on a thread in this forum that I should check the 3.3V pin and the Program and Reset pins. I get 3.3V on the three of them, and both Program and Reset pins go to 0V when I push the Reset button.
I just came across a thread in the Adafruit forum where someone says his board only works when pressing on the chip.
https://forums.adafruit.com/viewtopic.php?f=19&t=125796
I just tried it and it works. When I apply a lot of pressure with my thumb on the chip while connected via USB to my pc, the teensyduino sees it, but I have to maintain a lot of pressure.
The moment I let go a little bit the connection breaks.
Has anyone experienced this? Do you think reballing could bring the teensy back to life? what temperature and time should I try in that case?
I have a Teensy 3.6 that I bought a while ago and used it for some tests, and have been sitting in a drawer until now.
When I connect it to a pc (tried on two pcs, windows and linux) it doesn't appear. The blink sketch is long gone so I can't use that for knowing if it works.
I saw on a thread in this forum that I should check the 3.3V pin and the Program and Reset pins. I get 3.3V on the three of them, and both Program and Reset pins go to 0V when I push the Reset button.
I just came across a thread in the Adafruit forum where someone says his board only works when pressing on the chip.
https://forums.adafruit.com/viewtopic.php?f=19&t=125796
I just tried it and it works. When I apply a lot of pressure with my thumb on the chip while connected via USB to my pc, the teensyduino sees it, but I have to maintain a lot of pressure.
The moment I let go a little bit the connection breaks.
Has anyone experienced this? Do you think reballing could bring the teensy back to life? what temperature and time should I try in that case?