Vienna audio
Member
Hi,
It's some time i'm studying and developing a modular synth, but as i'm mainly a musician i still have some doubts .
Could you please have a look at the schematics?
This board is directly connected with the panel of the synth and is meant to process the cv inputs and basically to provide data input/output
Teensy 3.6 is on a secondary board together with the rest of the hardware.
On the right side there are all panel knobs, on left side all CVs.
There are also 15 switches whose value is meant to be red by an expander and some of them are also connected to a LED.
2 PWM LEDs and a CV output.
Do you see anything wrong?
View attachment Schematic_601REV3_Sheet-1_20190426084849.pdf
Thanks a lot for your time
It's some time i'm studying and developing a modular synth, but as i'm mainly a musician i still have some doubts .
Could you please have a look at the schematics?
This board is directly connected with the panel of the synth and is meant to process the cv inputs and basically to provide data input/output
Teensy 3.6 is on a secondary board together with the rest of the hardware.
On the right side there are all panel knobs, on left side all CVs.
There are also 15 switches whose value is meant to be red by an expander and some of them are also connected to a LED.
2 PWM LEDs and a CV output.
Do you see anything wrong?
View attachment Schematic_601REV3_Sheet-1_20190426084849.pdf
Thanks a lot for your time