Hi:
My PCB manufacturer made a mistake and connected the supply 3.3V (suppose for Vin) to all the 3.3V pins on the teensy (3.2 and 3.6), will it work or damage the board?
Initial power up all the chips were working but after sometime it stops.
I am supplying from a power bank via LD1117 voltage regulator.
My PCB manufacturer made a mistake and connected the supply 3.3V (suppose for Vin) to all the 3.3V pins on the teensy (3.2 and 3.6), will it work or damage the board?
Initial power up all the chips were working but after sometime it stops.
I am supplying from a power bank via LD1117 voltage regulator.