Hi everyone,
Here is my setup :
Teensy 3.2 + octo adapter board + ws2812b led strip (30 led for now) with a power supplie 5v 20A.
Teensy is powered by usb, and the led with the power supplie.
My wiring is the following :
5V+PSU --> 5v+ Led strip
5V- PSU --> GND Led strip & Ground (orangewhite Cat6 cable) Octows2811
Data (Orange cat6 cable) --> din Ledstrip
When i upload a program on the teensy all the leds goes full white, no matter what the program is .
Also i noticed the first led seems to have a slightly different color.
So, i check if the cat6 cable was correctly cabled, it is.
I tried with others portions of led strip, the same happen.
I have soldered the teensy to the octows2811, i checked if the solder was too bad, but looks fine (i think).
Anyone had this issue in the past ?
Thanks.
ps :
I am gonna try to add some photos tomorow, but if someone has a guess that would be awesome.
Here is my setup :
Teensy 3.2 + octo adapter board + ws2812b led strip (30 led for now) with a power supplie 5v 20A.
Teensy is powered by usb, and the led with the power supplie.
My wiring is the following :
5V+PSU --> 5v+ Led strip
5V- PSU --> GND Led strip & Ground (orangewhite Cat6 cable) Octows2811
Data (Orange cat6 cable) --> din Ledstrip
When i upload a program on the teensy all the leds goes full white, no matter what the program is .
Also i noticed the first led seems to have a slightly different color.
So, i check if the cat6 cable was correctly cabled, it is.
I tried with others portions of led strip, the same happen.
I have soldered the teensy to the octows2811, i checked if the solder was too bad, but looks fine (i think).
Anyone had this issue in the past ?
Thanks.
ps :
I am gonna try to add some photos tomorow, but if someone has a guess that would be awesome.