the_duckchild
Member
Hopefully this is not too dumb a question...
I'm just assembling a large MIDI controller which has 36 pots and 47 buttons. I think I have enough 74HC4051 chips and pins available to make this work with either of the Teensy I have to hand.
It seems easier to use the ++ 2.0 and keep everything at 5v throughout, but before I start soldering...
Is there any possible advantage (latency wise of other reasons) in using the Teensy 3.2? or can I save this for a project that processes audio?
thanks for any advice on this.
I'm just assembling a large MIDI controller which has 36 pots and 47 buttons. I think I have enough 74HC4051 chips and pins available to make this work with either of the Teensy I have to hand.
It seems easier to use the ++ 2.0 and keep everything at 5v throughout, but before I start soldering...
Is there any possible advantage (latency wise of other reasons) in using the Teensy 3.2? or can I save this for a project that processes audio?
thanks for any advice on this.