FosterAnderson
New member
Hi,
I would like to use the Teensy 3.5 in an industrial automation project but I am worried that the bottom end of the temperature range (I need to be able to go down to -40 C).
I have read some threads on this forum about the 3.0/3.2 being used in low temperatures as long as the crystal is replaced:
https://forum.pjrc.com/threads/23752-Teensy-3-0-temperature-rating?p=32053&viewfull=1#post32053
and:
https://forum.pjrc.com/threads/33525-Temperature-rating
Is the crystal the limiting factor on the 3.5 as well?
Thanks
edit:
Just saw the sticky about posting in the general guidance section if no wires have been run yet, rookie mistake I suppose.
I will repost there, apologies
I would like to use the Teensy 3.5 in an industrial automation project but I am worried that the bottom end of the temperature range (I need to be able to go down to -40 C).
I have read some threads on this forum about the 3.0/3.2 being used in low temperatures as long as the crystal is replaced:
https://forum.pjrc.com/threads/23752-Teensy-3-0-temperature-rating?p=32053&viewfull=1#post32053
and:
https://forum.pjrc.com/threads/33525-Temperature-rating
Is the crystal the limiting factor on the 3.5 as well?
Thanks
edit:
Just saw the sticky about posting in the general guidance section if no wires have been run yet, rookie mistake I suppose.
I will repost there, apologies