Run teensy3.2 with labview using command line.

Status
Not open for further replies.

Abbasi

Member
hello everyone,
I want to run teensy3.2 through labview
Lets say,
I have a code of led blink saved in computer drive.
In LabVIEW, I want to make a button, means when I press it the save code from the directory
automatically burn in my teensy3.2
any kind of help will be appriciated, thanks.
 
I closed prior thread this duplicates.

Not seen how LabView is used here and how it could be expected to program a Teensy using the USB port protocol required.

There are command line ways of calling tools to program the Teensy - but doing it within some other program? Perhaps it has features needed to call out and do this - more info would be needed in any case
 
Thanks for your reply actually in lab view there is one System exec VI,
If I have these two command lines,
1-for the opening program from a specific location of PC
2-upload program to teensy

how can we get these two command lines.

so we can use this VI(System VI)

VI.PNG

In the below link I have already discussed on NATIONAL INSTRUMENT forum, they suggest "System exec VI" as shown in the picture above.
"
https://forums.ni.com/t5/LabVIEW/Sending-hex-file-on-USART-using-labview/m-p/3899296#M1106472
 
Status
Not open for further replies.
Back
Top