toddhacker
Member
Hi what I'm hoping to do is build a custom joystick that also has a few LED's integrated as well. I'm wondering if I can accomplish this with a single Teensy 3.5. I am able to load in the Complete Joystick example and the joysticks and buttons work as they are supposed to. I can separately wire up the LED's (neopixels) and upload a different sketch and the LED's will work. However I can't seem to use both the Joystick sketch and NeoPixel sketch at the same time. Meaning I can't seem to put both sketches into one and upload to the teensy.
I'm using the normal pins outlined in the example sketch for the joystick, and would be using pin 13 (not used by the joystick) for the LED's. I don't know it if has anything to do with switching the port, (LED NeoPixels sketch needs to be set to serial, Joystick needs to be set to USB Joystick). probably not.
Thanks.
I'm using the normal pins outlined in the example sketch for the joystick, and would be using pin 13 (not used by the joystick) for the LED's. I don't know it if has anything to do with switching the port, (LED NeoPixels sketch needs to be set to serial, Joystick needs to be set to USB Joystick). probably not.
Thanks.