LenShustek
Member
I'm not seeing any WiFi networks. Is there any known incompatibility between Teensy 3.5 and the ATWINC1500? Is the standard Arduino WiFi101 library the right one to use?
Running the ScanNetworks example sketch (with the pins changed via WiFi.setPins to CS=19, EN=20, IRQ=21, RST=22), it reports the board's correct MAC address, but it doesn't see any of the WiFi networks.
I updated to the latest of everything: Arduino IDE 1.8.9, Teensyduino 1.46, and WINC1501 Model B firmware 19.6.1. I tried lowering the processor speed 72 Mhz; no change. The ATWINC1500 is being powered by the Teensy 3.3V output, but those are the only two parts on the breadboard.
Any ideas, or things to try?
Running the ScanNetworks example sketch (with the pins changed via WiFi.setPins to CS=19, EN=20, IRQ=21, RST=22), it reports the board's correct MAC address, but it doesn't see any of the WiFi networks.
I updated to the latest of everything: Arduino IDE 1.8.9, Teensyduino 1.46, and WINC1501 Model B firmware 19.6.1. I tried lowering the processor speed 72 Mhz; no change. The ATWINC1500 is being powered by the Teensy 3.3V output, but those are the only two parts on the breadboard.
Any ideas, or things to try?