pauleffect
Member
Hi guys!
Im new to arduino programming (and programming in general).
I recently got a teensy 3.6 and it literally blew me away. Easy to use, awesome tutorials, a joy to work with.
However, I got this shield (h-nanoGsm) and I have no idea how to connect it to the teensy.
My end goal is to use the teensy as a hid device and send commands to it via internet/ bluetooth. I was hoping to power the gsm shield directly from the teensy. Is this possible? And if so, could I please get some guidance setting it up?
Also, if you have an idea as to how I could accomplish this (using a different gsm module), any pointers would be very appreciated.
Edit: From what I've been able to gather, the GND pin of the gsm board would go to the GND on the teensy, while the TX, RX would go to digital pins on the teensy. The VUSB would go to the VIN pin?
Im new to arduino programming (and programming in general).
I recently got a teensy 3.6 and it literally blew me away. Easy to use, awesome tutorials, a joy to work with.
However, I got this shield (h-nanoGsm) and I have no idea how to connect it to the teensy.
My end goal is to use the teensy as a hid device and send commands to it via internet/ bluetooth. I was hoping to power the gsm shield directly from the teensy. Is this possible? And if so, could I please get some guidance setting it up?
Also, if you have an idea as to how I could accomplish this (using a different gsm module), any pointers would be very appreciated.
Edit: From what I've been able to gather, the GND pin of the gsm board would go to the GND on the teensy, while the TX, RX would go to digital pins on the teensy. The VUSB would go to the VIN pin?
Last edited: