TelephoneBill
Well-known member
From the R.M. page 291, the only analog comparator OUTs to appear on T4 pins directly are ACMP3_OUT (GPIO_AD_B1_14) on Pin26, and ACMP4_OUT (GPIO_AD_B1_15) on pin27. These are pins both on the underside and require soldering for connection.
But I did notice on page 3357 that ACMP1..4 are inputs to XBAR1. I wondered if it may be possible to route one of the ACMPx_OUT through the XBAR to then come out on a topside T4 pin. The XBAR is a bit of a mystery to use, so any help here would be very much appreciated.
But I did notice on page 3357 that ACMP1..4 are inputs to XBAR1. I wondered if it may be possible to route one of the ACMPx_OUT through the XBAR to then come out on a topside T4 pin. The XBAR is a bit of a mystery to use, so any help here would be very much appreciated.