Sandro
Well-known member
Hi all,
I made a first and perfectly working prototype of an audio application, based on Teensy 3.6 (bought on June 2018) + Audio Adaptor + W25Q128JV flash memory:
Ready to make again the same project with a more elegant and compact arrangement, I made a beautifull PCB and bought 2 pieces of Teensy 3.6 boards. But unfortunately, with both these new boards, I have problems of audio noise (clicks and pops)... I tried to use the same code, the same Audio board.. no way..
In order to do a fully simmetric test, I should remove 20 wires from the 20 pin pads on the bottom of the old and working Teensy board to make: before doing this, I'd like to know if anyone haas encountered a similar problem, and if there any known difference in performance (hopefully not!!!) among Teensy 3.6 over the years .
Thank you
I made a first and perfectly working prototype of an audio application, based on Teensy 3.6 (bought on June 2018) + Audio Adaptor + W25Q128JV flash memory:
Ready to make again the same project with a more elegant and compact arrangement, I made a beautifull PCB and bought 2 pieces of Teensy 3.6 boards. But unfortunately, with both these new boards, I have problems of audio noise (clicks and pops)... I tried to use the same code, the same Audio board.. no way..
In order to do a fully simmetric test, I should remove 20 wires from the 20 pin pads on the bottom of the old and working Teensy board to make: before doing this, I'd like to know if anyone haas encountered a similar problem, and if there any known difference in performance (hopefully not!!!) among Teensy 3.6 over the years .
Thank you