WS2812Serial Question

Status
Not open for further replies.

gfvalvo

Well-known member
Hi All:

Is seen in the example code for the WS2812Serial libary the following line:
Code:
//   Teensy 3.2:  1, 5, 8, 10, 31   (overclock to 120 MHz for pin 8)
Just curious why the need for 120 MHz to use Pin 8.
Any insight appreciated.
Thanks.
 
Thanks Paul. I was just about to post that I found that info after digging through the datasheet for a while.
 
So, if I'm reading the datasheet and source code correctly, it looks like the Baud is actually set to 3.75 MHz on a T3.2 (overclocked) when Pin 8 / UART2 is selected. Right?
 
Status
Not open for further replies.
Back
Top