simonmaltby
Member
I hope you don't mind me reaching out on the forum. I have a commercial product which I use the Teensy LC board for but I am finding it difficult to mount the board flat because I use the USB pads to mount to another PCB and I have a USB cable going over the top of the Teensy, so need it as low and flat as possible.
Because of this I would like to build a custom PCB rather than combining the 2. That's the plan but I have no ability when it comes to electronics. I can bolt things together and design my PCB's in Eagle but its simply tracks connecting the Teensy to a couple of plugs.
All I am doing is connecting an 8 Pin JCT PH plug and a 6 PIN Wire header for the USB as you can see in the attachment.
Would anyone be willing to help me design a board that has the Teensy LC components built in? I am happy to pay as this is a commercial product that I sell.
I should add that my code is open source and can be downloaded by anyone... My product just combines various parts that you can buy off the shelf to make it easier for people to use. I would place the PCB design openly in the blog section and with the code.
Kind regards
Simon Maltby
Sim Racing Machines UK
Because of this I would like to build a custom PCB rather than combining the 2. That's the plan but I have no ability when it comes to electronics. I can bolt things together and design my PCB's in Eagle but its simply tracks connecting the Teensy to a couple of plugs.
All I am doing is connecting an 8 Pin JCT PH plug and a 6 PIN Wire header for the USB as you can see in the attachment.
Would anyone be willing to help me design a board that has the Teensy LC components built in? I am happy to pay as this is a commercial product that I sell.
I should add that my code is open source and can be downloaded by anyone... My product just combines various parts that you can buy off the shelf to make it easier for people to use. I would place the PCB design openly in the blog section and with the code.
Kind regards
Simon Maltby
Sim Racing Machines UK