Tensey 4.0 + Pi-4 Home Automation Perimeter Monitoring ....

Status
Not open for further replies.

EM1SSNuke

Member
Seems like a good solution. Quiet possibly 'way' overkill. :) ...

Tensey 4.0 for control of FLIR and associated. Data to Pi-4
Pi-4 for post processing engine and reporting via hardwired Ethernet or Wifi.

Thoughts? :)
 
Current requirements of Tensey 4.0? .. And where is the 50mA fuse located on the PCB?.... hmmm what are the 5V current draw requirements?
 
Okay mistyped, 500mA. So connecting to the PI-4 USB did work. Saw your blinking Amber LED. Need to follow the remaining instructions
 
Awesome, 100mA, much appreciated ... :)

Okay now i need help. Have Arduino on both Win10 and PI-4 Linux distro. Both at the most recent version of Arduino. Have not used Arduino. Am a old command line or Eclipse dev user for C lvl development. ... So therefore am an Arduino neo-fit. ... Seems like all the stuff may be there with the udev rules for linux, not sure yet.

Any hints?

Also, 4.0 is ARM based not AVR based, so different tool chain ... etc. Correct?
 
Last edited:
Yes, All Teensy 3.x, LC and 4.0 are ARM core processors - not AVR. Installing TeensyDuino gives the toolchain needed and updates the Arduino IDE to connect and build. There is an rPi build too.
 
Okay had to ... File->Sketchbook->Digital->Blink menu ==>> File->Examples->0.1 Basics->Blink ... is this the correct code for the T-4.0? What should it be mod'd to to test?
rPi build? ... nm ... smacks head Ras Pi ..
 
Okay had to ... File->Sketchbook->Digital->Blink menu ==>> File->Examples->0.1 Basics->Blink ... is this the correct code for the T-4.0? What should it be mod'd to to test?
rPi build? ... nm ... smacks head Ras Pi ..

All the general examples - except perhaps for hardware not yet ported - run as written - or in some cases as noted or adjusted within the example.

Blink will just run - selecte Teensy 4 as the board and Upload and modify as desired.

No specific PJRC plans to port any RTOS - there is a TeensyThreads that allows task switching - and other posters may have ports underway
 
Status
Not open for further replies.
Back
Top