I've just updated my various development PC's to Arduino 1.8.10 and Teensyduino 1.48, and find that I can no longer create HID devices. I'm looking specifically at anything with a joystick in it. This was working fine for me up until the update.
As an example of what is happening, I have just tried to load a program to a 3.6 that had previously been used so it already had a com port (7 in this case). the program apparently compiled OK and also seemed to upload OK, however no HID device was created in windows, and if I look in the IDE, the serial port is no longer there and I am back to a similar identifier as with a new device. Screenshots 1 & 2 attached show this.
I tried again with 'Everything' and while it appeared to make a port, nothing appeared in windows.
I tried again with Serial, Keyboard, Mouse, Joystick and got the a similar result see screenshots 4 & 5.
I have had occasions where a device does appear in windows, but it is at the bottom of the devices panel, and is permanently labelled as 'configuring device'
I done the update on 3 of my 4 regular PC's and get the same result on all of them.
I've attached the source code for the program I was trying to use.
Any thoughts would be welcome, before I uninstall and try to go back to the previous version.
As an example of what is happening, I have just tried to load a program to a 3.6 that had previously been used so it already had a com port (7 in this case). the program apparently compiled OK and also seemed to upload OK, however no HID device was created in windows, and if I look in the IDE, the serial port is no longer there and I am back to a similar identifier as with a new device. Screenshots 1 & 2 attached show this.
I tried again with 'Everything' and while it appeared to make a port, nothing appeared in windows.
I tried again with Serial, Keyboard, Mouse, Joystick and got the a similar result see screenshots 4 & 5.
I have had occasions where a device does appear in windows, but it is at the bottom of the devices panel, and is permanently labelled as 'configuring device'
I done the update on 3 of my 4 regular PC's and get the same result on all of them.
I've attached the source code for the program I was trying to use.
Any thoughts would be welcome, before I uninstall and try to go back to the previous version.
Attachments
Last edited: