Hello,
I allow myself to write to you because I need your help and advice in my project. I am new to the world of teensy.
I make an analog synthesizer controlled in "midi". For that I chose teensy (teensy 3.6). I made most of the schemas however I ask myself several questions.
The synthesizer is composed of 4 voices controlled separately via the MIDI controller. Each voice is composed of a teensy piloting DAC and digipot. In sum there are 5 teensy (one for the midi controller and 4 for each voice). 4 switch (1 per voice) to indicate to the MIDI controller which voice it controls (for example if the switch 3 is switched on then the controller controls the voice 3, if the switches 3 and 4 are on then the controller pilot the voice 3 and 4)
To communicate between the midi contoller and the voices I hesitate between two solutions.
The first one: I use a TX output of the teensy of the MIDI controller connected to the Rx of teensy voices, parralele I use 4 pin to indicate with which the controller midi communicates.If the pin is high then the teensy of the voice concerned listening.
The second: I multiplex the TX output of the MIDI controller with a 4051, which gives me 8 MIDI outputs.
(as http://little-scale.blogspot.com/2009/09/multiplexing-midi-output-streams-with.html)
According to you what would be the best solutions, I look for the fastest communication?
I profile to ask if it is possible to increase the speed of communication between the Teensy at noon, the baud is normally expected to 31250 however I imagine that between the Teensy we must be able to go up to 2Mbit / s ?
Very cordially
I allow myself to write to you because I need your help and advice in my project. I am new to the world of teensy.
I make an analog synthesizer controlled in "midi". For that I chose teensy (teensy 3.6). I made most of the schemas however I ask myself several questions.
The synthesizer is composed of 4 voices controlled separately via the MIDI controller. Each voice is composed of a teensy piloting DAC and digipot. In sum there are 5 teensy (one for the midi controller and 4 for each voice). 4 switch (1 per voice) to indicate to the MIDI controller which voice it controls (for example if the switch 3 is switched on then the controller controls the voice 3, if the switches 3 and 4 are on then the controller pilot the voice 3 and 4)
To communicate between the midi contoller and the voices I hesitate between two solutions.
The first one: I use a TX output of the teensy of the MIDI controller connected to the Rx of teensy voices, parralele I use 4 pin to indicate with which the controller midi communicates.If the pin is high then the teensy of the voice concerned listening.
The second: I multiplex the TX output of the MIDI controller with a 4051, which gives me 8 MIDI outputs.
(as http://little-scale.blogspot.com/2009/09/multiplexing-midi-output-streams-with.html)
According to you what would be the best solutions, I look for the fastest communication?
I profile to ask if it is possible to increase the speed of communication between the Teensy at noon, the baud is normally expected to 31250 however I imagine that between the Teensy we must be able to go up to 2Mbit / s ?
Very cordially