Hello everyone,
I intend to use a DAC AD5360 with my Teensy 3.6.
However, I wonder about the connections.
From the information I could find (datasheel / evaluation board / arduino library) the DAC should be connected as:
SDO / SDI / SCLK / SYNC (cs) go to the teensy SPI port.
LDAC / RESET / CLR go on digital pines
Vref0 / Vref1 go to + 5V (in my case)
SIGGND0 and 1 / AGND / DGND go to ground (Should we make a difference between DGND and AGND?)
However, I still have MON-IN0 and 1, MON-OUT , TEMP-OUT , GPIO , BUSY , BIN2SCOMP , and EP .... Where to connect them? Should we connect them?
all this is very distressing ... I like to be certain ...
Sincerely Anoat
I intend to use a DAC AD5360 with my Teensy 3.6.
However, I wonder about the connections.
From the information I could find (datasheel / evaluation board / arduino library) the DAC should be connected as:
SDO / SDI / SCLK / SYNC (cs) go to the teensy SPI port.
LDAC / RESET / CLR go on digital pines
Vref0 / Vref1 go to + 5V (in my case)
SIGGND0 and 1 / AGND / DGND go to ground (Should we make a difference between DGND and AGND?)
However, I still have MON-IN0 and 1, MON-OUT , TEMP-OUT , GPIO , BUSY , BIN2SCOMP , and EP .... Where to connect them? Should we connect them?
all this is very distressing ... I like to be certain ...
Sincerely Anoat