Teensy3.5

Status
Not open for further replies.
D

dispatch

Member
Hello

Please help me, point me in the correct direction, thanx,

Using a teensy 3.5
I am having little luck to figure out the code for a usb controller (Throttle controller).

this controller has
10 buttons (connected in a 3 x 4 matrix) and
5 Pots

Not sure how to code it , may have to rewire the buttons.?

Please help, your my only hope......
thnx
 
The project is a Thrustmaster Cougar Throttle.

found a site with everything, (wire diagram, matrix for buttons) except the sketch.
been working with other sketches, but not sure they are for the teensy, error in code.

Thanks again
 
Last edited:
Hello thanks for replying

Yes, Just trying to figure out how to add the button, matrix, would be GREAT - three rows by four columns.

would like to find a solution, but, if I can't find a solution, I will just rewire the matrix to single buttons.
someone (the mighty one) has done this before ...... still searching .....

thanks again :eek:
 
Ok Got it working, using the joystick code (from pjrc), rewired the buttons.
The test program shows all buttons on,
buttons turn off when pressed,
is there a way to invert the output of the switches?

Also the Analog inputs are a little jittery is there a solution , maybe capacitors on the inputs?

Thanks again


Still looking for the code for buttons connected in a matrix to go with the Joystick code
 
Status
Not open for further replies.
Back
Top