Hi,
It might be trivial but I'm missing something.
I received the new teensy 4.0 this week and it seems great.
Now, I'm trying to connect a usb-c breakout, so I could use the new type of cables. I'm using this kind of board- https://eu.mouser.com/new/adafruit/adafruit-4090-usb-c-breakout-board/ .
I connected the D+ and D- on the breakout board to the relevant pads on the bottom of the teensy, ground to ground and VBUS on the breakout to Vin in the teensy.
When I connect usb-c cable, the teensy gets its power but the laptop don't "see" it. Later, I disconnect the type-c and reconnect the laptop to teensy with the "normal" usb-micro connector and it was fine again (it appears in the laptop's ports list).
So, I probably misconnect the breakout.
Was I suppose to connect the breakout's VBUS to the teensy's VBUS and not to Vin? Is that matter? Am I suppose to connect anything else?
Thanks in advance.
It might be trivial but I'm missing something.
I received the new teensy 4.0 this week and it seems great.
Now, I'm trying to connect a usb-c breakout, so I could use the new type of cables. I'm using this kind of board- https://eu.mouser.com/new/adafruit/adafruit-4090-usb-c-breakout-board/ .
I connected the D+ and D- on the breakout board to the relevant pads on the bottom of the teensy, ground to ground and VBUS on the breakout to Vin in the teensy.
When I connect usb-c cable, the teensy gets its power but the laptop don't "see" it. Later, I disconnect the type-c and reconnect the laptop to teensy with the "normal" usb-micro connector and it was fine again (it appears in the laptop's ports list).
So, I probably misconnect the breakout.
Was I suppose to connect the breakout's VBUS to the teensy's VBUS and not to Vin? Is that matter? Am I suppose to connect anything else?
Thanks in advance.