Interesting. Do you have a link to the thread?
I’m also looking into EventResponder.
I’m pretty familiar with lots of the MCU UART spec, but I haven’t yet found why RDRF interrupts are halted if there’s incoming valid signal, the peripheral is enabled, and C2_RE and C2_RIE are set. I’ll be testing all other relevant configuration flags I can think of. Maybe other parameters get set incorrectly during this race or something.
I’m also looking into EventResponder.
I’m pretty familiar with lots of the MCU UART spec, but I haven’t yet found why RDRF interrupts are halted if there’s incoming valid signal, the peripheral is enabled, and C2_RE and C2_RIE are set. I’ll be testing all other relevant configuration flags I can think of. Maybe other parameters get set incorrectly during this race or something.