Recovery after Download error

Status
Not open for further replies.

jeff0778

Member
Hi,
I foolishly pulled the power halfway through an upload to a Teensy 3.5 board and now the board is no longer recognised as a USB / COM port on the PC and i can't upload to it.

The board was powered by secondary source and the USB cable had the 5v disconnected. I've been using a setup like this for months with no issues.

I've tried pressing, pressing and holding the reset button and nothing. I've also tried using a standard USB cable directly into the board and no com port comes up on the PC.

Have i corrupted something and is there a way to recover this ?

Cheers
 
Sorry, emergency over. I've recovered the teensy board from the custom board and after pressing the reset & holding it the device has come back online.. few..
 
Status
Not open for further replies.
Back
Top