ChrisHoward
Member
Hi,
I think this is my own fault.
I was trying to go cheap, didn't have any long-tailed female pin sockets.
So I used some stiff copper wire for pins.
But that lead to hard insertion force into my project board.
And hard removal too. I think that's when I did it.
When I applied power nothing happens.
Just between pin 11 and the reset button there are two small devices.
The one next to the button looks munched. I must have pried against
it I suspect.
So I need to order another Teensy 4.0.
While I'm waiting for that, could someone tell me what that device is?
Maybe I have one or something that would substitute.
Yes it is small. I have a microscope and the board is DOA,
so why not give it a try.
I think this is my own fault.
I was trying to go cheap, didn't have any long-tailed female pin sockets.
So I used some stiff copper wire for pins.
But that lead to hard insertion force into my project board.
And hard removal too. I think that's when I did it.
When I applied power nothing happens.
Just between pin 11 and the reset button there are two small devices.
The one next to the button looks munched. I must have pried against
it I suspect.
So I need to order another Teensy 4.0.
While I'm waiting for that, could someone tell me what that device is?
Maybe I have one or something that would substitute.
Yes it is small. I have a microscope and the board is DOA,
so why not give it a try.