I am working on a project that requires 4 stepper motors, 11 LED pwm dimmers, and 2 or 3 voice channels. I had been working with Arduino Mega and was running into number of timer limitations with running that many channels of PWM and steppers and then definitely hit a wall when I needed more than one voice channel, the poor little 8 bit guy just couldn't do it. So I started looking around and had heard about Teensy, dug in a bit and ordered a 3.5. Well it came yesterday, maybe too quick really, now I am trying to figure out how to proceed without running down 100 rabbit holes. I had thought I saw somewhere that there were many timers on one of these chips but now it seems it may be even more limited for PWM type channels than Mega. Is it just the chip that has these multitude of timers and they are not wired out on the board. I really don't have a clue at this point. I guess what I am asking is what is the best way to proceed to configure to get my 4 stepper, 11 pwm's ?
Looking at the voice part it would seem to be a piece of cake. It really looks like a complete other world here compared to where I have been with the development and ease of use just over the top really. Kudos to the team there!
Looking at the voice part it would seem to be a piece of cake. It really looks like a complete other world here compared to where I have been with the development and ease of use just over the top really. Kudos to the team there!