I am making an audio device using teensy 3.2
I was hoping to use ten turn pots to control some of the parameters,
example:
https://www.amazon.com/JANSANE-Pote...k+10+turn+potentiometer&qid=1581357245&sr=8-3
but when I change from standard pots the print monitor shows all sorts of unexpected behaviour.
example:
https://www.amazon.com/uxcell-Carbo...keywords=potentiometer&qid=1581357326&sr=8-56
I expected the ten turn pots to behave in the same way, but this is a surprise.
The sketch works with the standard breadboard mount pots, but then things stop making sense with the ten turn pots substituted.
Has anyone else come across this problem, and are there any suggestions to try so it will behave like other pots??
I was hoping to use ten turn pots to control some of the parameters,
example:
https://www.amazon.com/JANSANE-Pote...k+10+turn+potentiometer&qid=1581357245&sr=8-3
but when I change from standard pots the print monitor shows all sorts of unexpected behaviour.
example:
https://www.amazon.com/uxcell-Carbo...keywords=potentiometer&qid=1581357326&sr=8-56
I expected the ten turn pots to behave in the same way, but this is a surprise.
The sketch works with the standard breadboard mount pots, but then things stop making sense with the ten turn pots substituted.
Has anyone else come across this problem, and are there any suggestions to try so it will behave like other pots??