I would like to connect a 100K trim pot to my teensy 3.6 but I read that the 3.3V pin can only handle 250mA max. If the resistance is set to the lowest, will it cause an over current draw?

I was planning to hook up from left to right: 3.3V , A0 , GND.

This was the code I was planning to use:

Code:
void setup()
{                
  Serial.begin(38400);
}

int val;

void loop()                     
{
  val = analogRead(0);
  Serial.print("analog 0 is: ");
  Serial.println(val);
  delay(250);
}