Hi all, i have a bunch of teensys that i'm always working on, many inside custom MIDI controllers and I've gotten used only having the 1 teensy i'm working on plugged to my computer. I do that to avoid uploading to the wrong Teensy.
However i was going thru an old box of broken boards and i had 2 teensy 3.2s with ripped off USB pads so i figured i could use one as a USB to MIDI DIN and vice-versa box, I put wired up a MIDI IO circuit and did a quick test and worked great so i left it plugged in.
Then i went back to work on another 3.2 and i accidentally uploaded the sketch to the USB to MIDI DIN box, maybe it's a bad habit to not check what port is selected...
I did some searches on the forum and i found the FSEC mod so i gave it a try and that did prevent the sketch from uploading to the board, i got the error on the IDE to press the PROGRAM button, i did that and i was able to upload a sketch.
However the board still shows up on the port list that can make it confusing if i have another teensy 3.2 showing as well.
Is there a way to block the IDE from seeing that specific board? and if so would i still be able to upload new firmware by pressing the PROGRAM button?
However i was going thru an old box of broken boards and i had 2 teensy 3.2s with ripped off USB pads so i figured i could use one as a USB to MIDI DIN and vice-versa box, I put wired up a MIDI IO circuit and did a quick test and worked great so i left it plugged in.
Then i went back to work on another 3.2 and i accidentally uploaded the sketch to the USB to MIDI DIN box, maybe it's a bad habit to not check what port is selected...
I did some searches on the forum and i found the FSEC mod so i gave it a try and that did prevent the sketch from uploading to the board, i got the error on the IDE to press the PROGRAM button, i did that and i was able to upload a sketch.
However the board still shows up on the port list that can make it confusing if i have another teensy 3.2 showing as well.
Is there a way to block the IDE from seeing that specific board? and if so would i still be able to upload new firmware by pressing the PROGRAM button?