Teeny 3.6 off battery power peak and Sleep Current Draw

Status
Not open for further replies.

gary01

Member
hi

I am trying to run the teensy 3.6 in a remote application for IOT and using a solar panel charging a battery, i need to know how many milliams the teensy will draw if i wake up say every 30 seconds to read inputs and outputs for say 10 seconds, then sleep again.

all suggestions are greatly appricated, looking at a 6v battery with stepdown. 4.5 AH something like this https://www.takealot.com/securi-pro...H9lgmMNhxXGzTs5BMlEaAqr_EALw_wcB&gclsrc=aw.ds

as always your suggestions are apprichated and the Teensy is a wonderfull product.

thanks Gary
 
Power while awake will depend mostly on your chosen clock rate so keep it it as slow as possible. If you really be asleep for only 75% of the time then the sleeping current draw doesn't matter as much.

I dug through my notes and found where I measured current at 3mA in SLEEPDEEP. When running it was around 50mA.
 
Status
Not open for further replies.
Back
Top