Pins teensy 3.6 to Audio board Rev B

Status
Not open for further replies.

Eester

New member
Hi I’m newbie here, I have teensy 3.6 want to connect audio board Rev B together . The correct way to mount together I’m very confused using 14 pin header pin do I skip one not used ? Or must be hard wired in ? Which pins match up with teensy 3.6 to audio board rev B ? Can someone show me me pin for pin thank you
 
This way:
teensy3_audio_quadch.jpg

Note, the headphone-connector and USB are on the same side. The 3.6 is longer than the audio shield - ignore that ;)
Don't use wires - if you don't do it right they can be very unreliable, and soon we will read "Audio shield does not work" from you...

More information: https://www.pjrc.com/store/teensy3_audio.html
 

Attachments

  • teensy3_audio_quadch[1].jpg
    teensy3_audio_quadch[1].jpg
    58.2 KB · Views: 50
Which pins match up with teensy 3.6 to audio board rev B ? Can someone show me me pin for pin thank you

Connect it like this:

DSC_0730_web.jpg

DO NOT use wires. It must be mounted close to the audio shield, because rev B does not have the extra 100 ohm resistor on MCLK.
 
Status
Not open for further replies.
Back
Top