RichardFerraro
Well-known member
My system was working great, until a few weeks ago when excessive delay (almost a minute) between compile finishing and uploading to Teensy 3.6
After the delay started, I updated to Arduino 1.8.11 and TeensyDuino 1.50 but the delay remained.
I have McAfee with real-time scanning turned off.
I am using TyCommander, but the delay is the same if I use the Teensy loader.
The program has a lot of components yet the compile is fast and it rapidly gets to:
"C:\\Arduino\\hardware\\teensy/../tools/arm/bin/arm-none-eabi-size" -A "C:\\Users\\Richa\\AppData\\Local\\Temp\\arduino_build_398176/Cat.ino.elf"
Sketch uses 720420 bytes (68%) of program storage space. Maximum is 1048576 bytes.
Global variables use 95452 bytes (36%) of dynamic memory, leaving 166692 bytes for local variables. Maximum is 262144 bytes.
However, then there is approx 60 second long delay with no output until:
C:\Teensy\TyTools-0.9.0-win64\TyCommanderC.exe upload --autostart --wait --multi C:\Users\Richa\AppData\Local\Temp\arduino_build_398176/Cat.ino.TEENSY36.hex
upload@6061510-Teensy Uploading to board '6061510-Teensy' (Teensy 3.6)
upload@6061510-Teensy Triggering board reboot
upload@6061510-Teensy Firmware: Cat.ino.TEENSY36.hex
upload@6061510-Teensy Flash usage: 704 kiB (68.7%)
upload@6061510-Teensy Uploading...
upload@6061510-Teensy Sending reset command
Any ideas?
After the delay started, I updated to Arduino 1.8.11 and TeensyDuino 1.50 but the delay remained.
I have McAfee with real-time scanning turned off.
I am using TyCommander, but the delay is the same if I use the Teensy loader.
The program has a lot of components yet the compile is fast and it rapidly gets to:
"C:\\Arduino\\hardware\\teensy/../tools/arm/bin/arm-none-eabi-size" -A "C:\\Users\\Richa\\AppData\\Local\\Temp\\arduino_build_398176/Cat.ino.elf"
Sketch uses 720420 bytes (68%) of program storage space. Maximum is 1048576 bytes.
Global variables use 95452 bytes (36%) of dynamic memory, leaving 166692 bytes for local variables. Maximum is 262144 bytes.
However, then there is approx 60 second long delay with no output until:
C:\Teensy\TyTools-0.9.0-win64\TyCommanderC.exe upload --autostart --wait --multi C:\Users\Richa\AppData\Local\Temp\arduino_build_398176/Cat.ino.TEENSY36.hex
upload@6061510-Teensy Uploading to board '6061510-Teensy' (Teensy 3.6)
upload@6061510-Teensy Triggering board reboot
upload@6061510-Teensy Firmware: Cat.ino.TEENSY36.hex
upload@6061510-Teensy Flash usage: 704 kiB (68.7%)
upload@6061510-Teensy Uploading...
upload@6061510-Teensy Sending reset command
Any ideas?