Forum Rule: Always post complete source code & details to reproduce any issue!
Results 1 to 3 of 3

Thread: ILI9341_t3 for STM32

  1. #1
    Junior Member
    Join Date
    Mar 2020
    Posts
    1

    ILI9341_t3 for STM32

    Hi, maybe someone has ported these display drivers for STM32? (non arduino)
    I would like to use non arduino code.

  2. #2
    Senior Member+ defragster's Avatar
    Join Date
    Feb 2015
    Posts
    11,560
    Not much here is non-Arduino … except it is all just c/cpp code … and perhaps less of anything STM anywhere here as the 32 bit Teensy's are all NXP products.

    perhaps mbed offers support or other STM specific github or other repository.

  3. #3
    Senior Member+ KurtE's Avatar
    Join Date
    Jan 2014
    Posts
    6,686
    First question is what do you mean by STM32? The Adafruit code runs on most Arduinos including STM32. But again you say no Arduino, so no idea of what underlying software you might be using.

    Some of the main differences from adafruits driver to the _t3 (or my _t3n) is that ours have been optimized to work with the T3 and T4 hardware... So I am not sure what you would gain by using it.

    Obviously if you were to say that you have a lot of T3.x boards and need to port your code over than it might make some sense.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •