I may be missing something here, but I’m coming up against a problem. I’ve built a board based around a custom teensy 3.6 using the boot loader chip. I’d like to flash my own serial number to the MK66 in the same way Paul does with the teensy’s, for this I’ve got a J-LINK SEGGER to connect via SWD, however, without breaking the links to the bootloader IC this fails to connect, due to the state it holds the lines in I'd imagine. Does anyone know a way to achieve this?
I’ve also noticed that even on my custom one the MAC address reports back as 04:E9:E5:FF:FF:FF, so still contains the PJRC vendor ID, I was expecting it to report back as FF:FF:FF:FF:FF:FF. Is this flashed in by the bootloader IC or is there a way to change it?
Thanks.
I’ve also noticed that even on my custom one the MAC address reports back as 04:E9:E5:FF:FF:FF, so still contains the PJRC vendor ID, I was expecting it to report back as FF:FF:FF:FF:FF:FF. Is this flashed in by the bootloader IC or is there a way to change it?
Thanks.