Hello!
I have been reading a lot about the OctoWS2811, and found some good info on this forum.

Since I am very new to the OctoWS2811, would anyone have any advice on how to switch the axis on an existing setup?

In this link, it appears as the LED strips are running Left to Right - as in Paul's Video wall demo.

https://forum.pjrc.com/threads/31672...b-amp-Hardware

Rather than having all of the inputs on the left, would it be possible to have the led strips run bottom to top, and put the OctoWS2811 inputs at the bottom of each strip?

Thank you for any advice you can provide!