CS42448 boot issues

Status
Not open for further replies.
I'm working on a project with the CS42448 codec on a Teensy 4.0. As long as I flash the firmware after boot the audio system comes up but if I restart the board without being plugged into the computer the codec doesn't function until flashed again. Has anyone else run into this?
 
You have to reset the codec and configure it after the teensy has been reset. Did you connect a pin on the teensy to control the codec reset?
 
Ah, thanks. I have the CAT811 chip but it may not be wired properly. I'll hook that up to a free pin to have it boot after the teensy.
 
Status
Not open for further replies.
Back
Top