Hello everyone,
I am fairly new to this world and need some guidance for a project I have. The current setup I have might seem dumb but it's not permanent. It's just a step for me to learn how to establish communication between an instrument, a teensy board and my laptop.
Here's the setup... I have an optical particle counter with a 3 pin rs232 serial port sending data at a 9600 baud rate. I have connected this port to a max3232 transceiver breakout (for rs232 to ttl conversion) which is then in turn connected to the serial port #2 on my teensy (pins 9 and 10). The teensy is then connected to my laptop with the USB cable.
I have looked at different examples and the serial library but I am a bit lost at the moment. How do I make my teensy read the incoming data on serial port 2 and then send it directly to my computer so I can read it on the serial monitor?
I hope my explanation is clear. Thank you very much for any help!
Cheers,
Roman
I am fairly new to this world and need some guidance for a project I have. The current setup I have might seem dumb but it's not permanent. It's just a step for me to learn how to establish communication between an instrument, a teensy board and my laptop.
Here's the setup... I have an optical particle counter with a 3 pin rs232 serial port sending data at a 9600 baud rate. I have connected this port to a max3232 transceiver breakout (for rs232 to ttl conversion) which is then in turn connected to the serial port #2 on my teensy (pins 9 and 10). The teensy is then connected to my laptop with the USB cable.
I have looked at different examples and the serial library but I am a bit lost at the moment. How do I make my teensy read the incoming data on serial port 2 and then send it directly to my computer so I can read it on the serial monitor?
I hope my explanation is clear. Thank you very much for any help!
Cheers,
Roman