Forum Rule: Always post complete source code & details to reproduce any issue!
Results 1 to 2 of 2

Thread: Mounting issues

  1. #1

    Mounting issues

    I want to mount the audio board below the Teensy 4.0 but that is interfering with the mic placement. How long can I safely make the wires on the mic without causing problems?

    Since the buttons are on the teensy placing it underneath makes no sense to me, but the mic is placed so that will not work. If I add a little bit of stiff wiring I should be able to make it work, but I don't want to be picking up rf with too long a wire, thus my question.

    Rich

  2. #2
    Senior Member
    Join Date
    Aug 2016
    Location
    Australia
    Posts
    161
    Your "a little bit of stiff wiring" should be OK. An inch or two is a reasonable limit for unshielded wire.

    The mic cable can be yards long without affecting quality, when shielded cable is used.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •