"Vin" pin too close to confort

Status
Not open for further replies.

3dlinux

Member
Hi there, I just soldered the pins on 4.1 board. Looks like the Vin pin is too close to the USB pad. Is there a bridge on the board there? Can I use it as is in the pictures?

Thanks,
 

Attachments

  • Annotation 2020-07-02 124653.jpg
    Annotation 2020-07-02 124653.jpg
    101 KB · Views: 57
  • Annotation 2020-07-02 1246532.jpg
    Annotation 2020-07-02 1246532.jpg
    87.4 KB · Views: 63
They are supposed to be connected. It is this wire on the schematic.

schematic41.png

This connection allows you to easily get access to the 5V power, or to power the board by putting 5V on the VIN pin
 
Thanks for the schematic!

I'm trying to attach two ideal diodes (MAX40200) so either Vin or Vusb can supply power without issues.

I appreciate the information.
 
Status
Not open for further replies.
Back
Top