True bidirectional logic level shifter

Status
Not open for further replies.

mah

Well-known member
Hi, I'm want to send and receive eurorack/synth gates with a teensy 4.1, the gates should be 5v but as the teensy is 3.3 v so I need to shift both up and down, and I also want to use software to change if a pin should send or receive a gate signal. What are my options?
 
Yeah, I know Paul suggested that the some of those was not a good option for some applications, but don't remember the specifics right now. Maybe it will be fine
 
"Since this chip is a special bi-directional level shifter it does not have strong output pins that can drive LEDs or long cables, it's meant to sit on a breadboard between two logic..." I guess a gate would draw very little current but the cables could be maybe 1-2m maximum, I don't know if that's considered long
 
Status
Not open for further replies.
Back
Top