Dead Teensy 3.2

Status
Not open for further replies.

jkoffman

Well-known member
Hi all,

I was just in the middle of uploading some code to a Teensy 3.2 when the cable came loose. The unit no longer seems to show up in Windows or OSX.

Any chance of reviving this, or is it time to plan a funeral?

Thank you!
 
To be clear, I don't think anything is unsoldered. The USB cable came out of the connector, that's all.

Thanks!
 
Open the IDE and do a VERIFY build on a known good BLINK sketch - that should open and prep TeensyLoader.

Then while pressing the Teensy Button - securely plug the USB cable into the Teensy.

Then release the Button.

It should then trigger TeensyLoader to put on the BLINK sketch to see that special blinking effect.
 
That did it, THANK YOU!

Now to continue on breaking my code, but with working hardware...

Thank you again!
 
Status
Not open for further replies.
Back
Top