Jaco Versfeld
Member
Good day,
I would like to connect a hydrophone with pre-amp (PIP) to the audio Shield (Audio Shield 4 Rev D). Can I simpy solder the wires to the MIC terminals? Where can I find the commands to set the SGT5000 Mic bias? I assume I will need to scale down gain on amplifiers of the SGT5000 as well?
Thanks
Jaco
I would like to connect a hydrophone with pre-amp (PIP) to the audio Shield (Audio Shield 4 Rev D). Can I simpy solder the wires to the MIC terminals? Where can I find the commands to set the SGT5000 Mic bias? I assume I will need to scale down gain on amplifiers of the SGT5000 as well?
Thanks
Jaco