I have a brushless dc motor and controller from a rc car. I want to eliminate the rc part and wire it to one axis of ajoy stick, along with a stepper motor on the other axis that would be used for steering, The connection on the motor controller for the receiver is 5v. There is a servo tester that can be hooked up to run the motor without the rc receiver, it just has a pot to control speed, I would need reverse as well for both motors. There will also be a third motor, another stepper that would just have a toggle switch for forward and reverse.
I have 2-L298N Dual H Bridge DC Stepper Servo Motor Drivers and a teensy 3.2 My question is would the the 3.2 be able to control all 3 motors?
I have 2-L298N Dual H Bridge DC Stepper Servo Motor Drivers and a teensy 3.2 My question is would the the 3.2 be able to control all 3 motors?