Mike Maurice
Active member
I had a little trouble installing vsCode, but the only issue that I can't seem to find a way around or any references online about is the following message:
Firmware too big (max 1048576 bytes)
Uploads of this source compiled from the Teensyduino IDE work without problems, if the source is compiled in it. It is just the hex compiled in the vsCode build.
The vsCode hex is about 40K and the ELF is about 350K.
I have tried using the tyCommander and it's variants. Also, using the Arduino uploader from the IDE.
Here is the code:
#include "Arduino.h"
void setup()
{
pinMode(LED_BUILTIN,OUTPUT);
}
void loop()
{
digitalWriteFast(LED_BUILTIN,!digitalReadFast(LED_BUILTIN));
delay(500);
}
Any suggestions?
Firmware too big (max 1048576 bytes)
Uploads of this source compiled from the Teensyduino IDE work without problems, if the source is compiled in it. It is just the hex compiled in the vsCode build.
The vsCode hex is about 40K and the ELF is about 350K.
I have tried using the tyCommander and it's variants. Also, using the Arduino uploader from the IDE.
Here is the code:
#include "Arduino.h"
void setup()
{
pinMode(LED_BUILTIN,OUTPUT);
}
void loop()
{
digitalWriteFast(LED_BUILTIN,!digitalReadFast(LED_BUILTIN));
delay(500);
}
Any suggestions?
Last edited: