Just a quick update..
After a few hours of going through documentation and experimenting, I finally found how to switch the timer output to pin #33
I started by setting pin 33 to FlexPWM_PWM2_B00 output
Set PWM2_B00 lower value
Then enabled PWM2_B00
Next step is to implement the 16 bit color transfer to the DMA kickoff function and callback.
Hopefully I can come back with some "good news" in the next few days when I find time to mess around with this a little more.
After a few hours of going through documentation and experimenting, I finally found how to switch the timer output to pin #33
I started by setting pin 33 to FlexPWM_PWM2_B00 output
Code:
IOMUXC_SW_MUX_CTL_PAD_GPIO_EMC_07 = 1;
Set PWM2_B00 lower value
Code:
FLEXPWM2_SM0VAL5 = 6;
Then enabled PWM2_B00
Code:
FLEXPWM2_OUTEN |= FLEXPWM_OUTEN_PWMB_EN( 1 );
Next step is to implement the 16 bit color transfer to the DMA kickoff function and callback.
Hopefully I can come back with some "good news" in the next few days when I find time to mess around with this a little more.