hi there,
i need a 12-bit resolution for some of my analog measurements in a project, so i change the resolution in setup() like so:
analogReadResolution(12);
other parts of the code need only a 10 bit resolution.
since this project should run at low latency... is there any speed difference in reading 12 bits and bitshift by 2 (>>2) v.s. setting the resolution to 10bit?
i need a 12-bit resolution for some of my analog measurements in a project, so i change the resolution in setup() like so:
analogReadResolution(12);
other parts of the code need only a 10 bit resolution.
since this project should run at low latency... is there any speed difference in reading 12 bits and bitshift by 2 (>>2) v.s. setting the resolution to 10bit?