RCProjects
Member
Hi.
I needed a board with 5V tolerant pins and a true analog output (DAC). So 3.2 seemed to fit the bill.
However, now I'm trying to connect a LoRa module to that board (Ra-01 containing SX1278), and the sample Rx code does not work: the LoRa fails to initialize.
I have connected the same LoRa module to an M0 board (Seeed), and it works fine.
When looking at the pinout for 3.2, I don't see any MISO and MOSI ports. I used pins 11 and 12 for those (as the only remaining SPI pins), but maybe that is incorrect.
Any tips or ideas would be appreciated ))
Nick.
I needed a board with 5V tolerant pins and a true analog output (DAC). So 3.2 seemed to fit the bill.
However, now I'm trying to connect a LoRa module to that board (Ra-01 containing SX1278), and the sample Rx code does not work: the LoRa fails to initialize.
I have connected the same LoRa module to an M0 board (Seeed), and it works fine.
When looking at the pinout for 3.2, I don't see any MISO and MOSI ports. I used pins 11 and 12 for those (as the only remaining SPI pins), but maybe that is incorrect.
Any tips or ideas would be appreciated ))
Nick.