Access to Teensy pins through Blackaddr audio board

Status
Not open for further replies.
M

mogplus8

Member
Hi All,

I have been playing with the audio board from Blackaddr and very impressive it is. However I have a problem. I have a Teensy 3.6 installed in mine, and I know not all the pins are used, so my question is, how do I physically access the other pins? I have the expansion board as well with two switches and three pots, but how do I add more switches and/or pots? I've seen stomp boxes with 8 buttons and lots of controls (I didn't actually count them...) including a pedal control. So if I built something like that how can I connect it all to the Teensy?

Thanks.
 
If you need even more I/O pins then are broken out on the TGA Pro, you can solder wires to directly to any unused pins on the TGA pro socket (the solder joints that are on the opposite side that the socket is installed on). Use the TGA Pro schematic to determine which pins are available.

Alternatively you could also solder directly to Teensy itself, same idea. Solder wires to the header solder joints.
 
Status
Not open for further replies.
Back
Top