Hello, New to teensy and I want to make sure I dont blow it up. I have a few questions.
1. I would like to further protect the board incase my voltage input goes higher. Is is ok to add a fuse for the 5v VIN ? Also Any suggest on fuse size ?
2. I will be using 6 serial ports for communication. I need to run a ground from the Teensy to all 6 of my devices. Do I have to use the one GND OR are all GNDs on the board equal ?
3. Also would like to confirm which pads to cut for voltage isolation to the USB. If I cut the pads, does that mean I can run power to +5v and keep the compter connected to USB ?
Thanks for your help.
1. I would like to further protect the board incase my voltage input goes higher. Is is ok to add a fuse for the 5v VIN ? Also Any suggest on fuse size ?
2. I will be using 6 serial ports for communication. I need to run a ground from the Teensy to all 6 of my devices. Do I have to use the one GND OR are all GNDs on the board equal ?
3. Also would like to confirm which pads to cut for voltage isolation to the USB. If I cut the pads, does that mean I can run power to +5v and keep the compter connected to USB ?
Thanks for your help.