I want to make sure I understand, fully, what cutting the trace means. I would actually like to wire in a switch so I don't have to solder/unsolder frequently. This Just disconnects the USB +5 from the VIN? Will I still be able to power from USB if VIN is not connected, or must VIN be connected? If I put a switch on this, can I activate it while USB is connected?
Second, what is the pitch of the ethernet port pads, it is smaller than 0.1, is there a part number for the dual row pins I need to get?
I downloaded the image from pjrc.com and modified it slightly with the callouts, hope this is OK.
Second, what is the pitch of the ethernet port pads, it is smaller than 0.1, is there a part number for the dual row pins I need to get?
I downloaded the image from pjrc.com and modified it slightly with the callouts, hope this is OK.