Hi,

iam using the standard BMP280 test library from adafruit. And there is a problem because the Teeny is not printing anything in the console. Do you have any ideas what the issue could be?

Best regards

Leon

HTML Code:
#include <Wire.h>
#include <SPI.h>
#include <Adafruit_BMP280.h>
#include <Servo.h>

#define BMP_SCK  (13)
#define BMP_MISO (12)
#define BMP_MOSI (11)
#define BMP_CS   (10)

int ground = 0;
int aktuell = 0;
int maxwert = 0;

Servo servo;

//Adafruit_BMP280 bmp; // I2C
Adafruit_BMP280 bmp(BMP_CS); // hardware SPI
Adafruit_BMP280 bmp(BMP_CS, BMP_MOSI, BMP_MISO,  BMP_SCK);

void setup() {
  


  Serial.begin(9600);
  Serial.print("Hello");
  servo.attach(3);
  servo.write(90);

  Serial.println(F("BMP280 test"));
  servo.write(70);
  if (!bmp.begin()) {
    Serial.println(F("Could not find a valid BMP280 sensor, check wiring!"));
    while (1);

  }


  /* Default settings from datasheet. */
  bmp.setSampling(Adafruit_BMP280::MODE_NORMAL,     /* Operating Mode. */
                  Adafruit_BMP280::SAMPLING_X2,     /* Temp. oversampling */
                  Adafruit_BMP280::SAMPLING_X16,    /* Pressure oversampling */
                  Adafruit_BMP280::FILTER_X16,      /* Filtering. */
                  Adafruit_BMP280::STANDBY_MS_500); /* Standby time. */
  ground = bmp.readAltitude();
  maxwert = ground;
  aktuell = ground;
  servo.write(90);
  
}

void loop() {
   // Serial.print(F("Temperature = "));
    //Serial.print(bmp.readTemperature());
    //Serial.println(" *C");

    Serial.print(F("Pressure = "));
    Serial.print(bmp.readPressure() / 100);
    Serial.println(" hPa");

    Serial.print(F("Approx altitude = "));
    Serial.print(bmp.readAltitude(1013.25)); /* Adjusted to local forecast! */
    Serial.println(" m");

}