Calibretto
New member
Hi everyone,
I made a board with a Teensy 4.1 plugged into it. I also put a magjack on it for ethernet. After the first version of the board didn't work, I read a paper on ethernet layout design rules and re-did the board. Still I can't get any connection. What am I missing? The PJRC Ethernet kit just works fine and it's plain ribbon cable.
I attached the schematics and layout. Can someone have a look at it?
I'm using a PulseJack J0011D01BNL MagJack, which has the same pinout and dimensions as the connector used on the PJRC kit.
Any help with this would be much appreciated, since I've run out of ideas.
I made a board with a Teensy 4.1 plugged into it. I also put a magjack on it for ethernet. After the first version of the board didn't work, I read a paper on ethernet layout design rules and re-did the board. Still I can't get any connection. What am I missing? The PJRC Ethernet kit just works fine and it's plain ribbon cable.
I attached the schematics and layout. Can someone have a look at it?
I'm using a PulseJack J0011D01BNL MagJack, which has the same pinout and dimensions as the connector used on the PJRC kit.
Any help with this would be much appreciated, since I've run out of ideas.